Samsat HD 80 CCcam Setup

Using USB and CCcam.cfg file:

Menu / Tools / CAS  /CAS Options / network sharing / read cccam.cfg from usb/ok

Manual Setup:

1- Unplug the receiver from the internet
2- Menu —> Tools—> CAS —> CAS Options —> FCAS Options —>Serial Port Use : disable GBOX SSSP and activate Morebox Protocol because you will also need to see his Morebox open channels…

If FCAS is not activated, with the remote press MENU and then dial 2 0 2 0 then FCAS enabled OK
3- Menu —> Tools—> CAS —> CAS Options —> FCAS Options —> Network sharing —-> ENABLE Network sharing !!!
4- Menu —> Tools—> CAS —> CAS Options —> FCAS Options —> Network sharing —- > CCcam servers —> Server 1 (you can choose server 1 ou 2 ou 3 ou 4 ou 5 +++) :

Fill CCCAM Server data in order using the remote control:
– HOST
– PORT
– USER
– PASS

 

Now the configuration of TCP / IP data Samsat receiver :
Menu —-> Congig Système —> Paramètres TCP/IP
Now check:

IP Auto = activated
Auto Obtain DNS: disable

Connect your Samsat HD80 to your ADSL Router with RJ45 cable …and wait 1 minute for the connection …!

Was this answer helpful?

 Print this Article

Also Read

Blade Media BM5000s

Load in the config file by USB just like before.Menu - Setup - Update & Backup - Image...

Openbox and Skybox CCcam Setup

ATTACH BOX TO POWER CABLE, SATELLITE CABLE, HDMI CABLE AND NETWORK CABLECLINE SETUP1: Go into the...

Engel RS 4800 Y CCcam Setup

1- Open notepad on pc.2- Enter your cccam lines 3- Save the file as CCcam_Newcamd.cfg4- Put the...

Ariva 150 CCcam Setup

DO NOT load any channel file from any other receiever as it will brick you box, only files for...

Spiderbox CCcam Setup

How to CCcam Setup for a Spiderbox via USB or remote controlWhat do you need?1. USB Stick2. Valid...