Blade Media BM5000s

Load in the config file by USB just like before.
Menu - Setup - Update & Backup - Image Upgrade
To enter a line manually press "Menu then 9991" on the remote.
Enter you C or N line details
Save (Yellow Button)
Exit out of all of the menus
You will now need to reboot the box, it doesn't do it automatically



If you want to enter a line by USB instead of typing in the details
Open the config file with notepad
C lines are at the top, N lines near the bottom, depending on what type you are using
Make sure you paste over the "#" at the start of each line you enter
Save the changes and put it on your pen drive
Menu - Setup - Update & Backup - Image Upgrade -Select the config file and reboot the box after it has loaded
To get the 7 day EPG, put a pen drive into the box or a USB HDD,
Press EPG on the remote, then download.
You should now be up and running

Was this answer helpful?

 Print this Article

Also Read

How to Make CCcam.cfg file

Most of the satellite receiver boxes need CCcam.cfg file with your CCcam lines in it in order to...

How to Setup CCcam on Technomate

To install cccam on technomate boxes, Simple procedure has to be followed. First start up your...

vu+ solo4k

Download link-oscam, are in etc/tuxbox/config/oscamConfig(replace user pass with your own on...

How to set cccam in Iris 9900 HD

In this tutorial I will try to explain briefly how to configure cccam in 9900 Iris HD decoders,...

Samsat HD 80 CCcam Setup

Using USB and CCcam.cfg file:Menu / Tools / CAS  /CAS Options / network sharing / read cccam.cfg...